The following components are used to install DayStar Filters to a variety of telescopes.  
Remember, Gold side mounts towards the Sun.  Red side towards the eye.

---

End Plates:
Edge-on profile of Flat Plate. Used as FRONT/GOLD Outer plate for ON-AXIS Refractor applications.	Edge-on profile of Wedge Plate. Used as FRONT/GOLD Outer plate for OFF-AXIS SCT applications.
Q3GF1F: Front, Gold Side Plate Fits Quantums. Has female 1.375" x 24 threads Available in Flat Q3GF1F or Wedge Q3GW1F Accepts 1.25" drawtube snouts. -$35 USD	Q3GFTF: Front, Gold Side Plate Fits Quantums. Has female T threads Available in Flat Q3GFTF or Wedge Q3GWTF Accepts T-Thread snouts or adapters.-$35 USD

---

Q3RFCTM: REAR, RED Side Plate
Fits Quantums. Has Combo choice w/ Male and Female
Q3RFC1M: Female 1.375" x 24 threads / Male 2" x 24
or  Q3RFCTM:Female T thread / Male 2" x 24 -$35 USD

---

Snouts & DrawTubes:

 
GF2SCTT: FRONT, GOLD Side snout -$45 USD
Fits Quantums. Has male T threads
Fits with Q3GWTF Front Gold plate (above)
Mounts on 2" T-thread telescope focusers.

GM1D1: Front, Gold Side drawtube snout
Has male 1.375" x 24 threads and male drawtube
Fits with Q3GF1F Front, Gold plate (above) -$35 USD

GM2DT: Front, Gold Side drawtube snout -$45 USD
Has male T-threads and male drawtube
Fits with Q3GFTF Front, Gold plate (above)

RF1D1: Rear, Red Side drawtube snout
Has male 1.375" x 24 threads and female drawtube
Fits with Q3RFC1M Rear, Red plate (above)-$35 USD

RF2D2: Rear, Red Side drawtube snout -$45 USD
Has female T-threads and female drawtube
Fits with Q3RFCTM or Q3RFC1M Rear, Red plate (above)